CNZTL Taile

Technical Guide

Comparing Chilled-Water Coil Quotations on the Same Basis

Published 17 November 2026

Before comparing chilled-water coil prices, check whether the quotations describe the same duty and supply scope. A catalogue capacity is not enough to establish equivalence. Ask each supplier to identify the conditions used for the offered selection and any difference from the project requirements.

Establish the air-side requirement

Provide the design airflow and entering-air temperature and moisture condition. This may be stated as dry-bulb and wet-bulb temperatures, or another agreed combination that defines the air condition. Identify the required leaving condition and total and sensible cooling duty where specified by the designer.

Compare the returned selection with those inputs. Where humidity control matters, ask the project designer to review the selected leaving-air condition alongside the system requirements. A total capacity figure alone does not establish the required moisture-control performance.

Establish the fluid-side requirement

State the fluid type, supply temperature and the specified return-temperature or flow basis. Identify glycol type and concentration where applicable, using an explicit concentration basis. Ask the supplier to state the fluid conditions actually used in the selection.

Record the selected flow and fluid-side pressure drop. If quotations use different flow rates or temperature differences, reconcile those differences before treating the offers as equivalent. Any fouling allowance and relevant water-quality requirements should be declared rather than assumed.

Compare the offered coil construction

Record the coil model, dimensions, rows, fin spacing, tube and fin materials, connections and other construction details required by the project. Ask which details are fixed and which remain subject to final selection.

Review face velocity, air-side pressure drop and condensate provisions for the selected duty. Confirm the drain-pan arrangement and access for inspection and cleaning where these are included in the supply. Row count or external dimensions alone cannot establish equivalent performance.

Keep the selection conditions attached to the price

Request a selection sheet showing the inputs and resulting performance. If the supplier revises the selection, retain the previous basis and identify what changed. Where a project specifies a rating or test standard, request evidence relevant to the offered model and have its applicability checked for the project.

General company certificates and reference photographs do not demonstrate that a particular coil meets the requested performance or approval requirements.

Compare inclusions separately

Place the equipment price beside its stated scope. Identify whether valves, strainers, flanges, insulation, controls, drain connections, freight and site work are included or excluded. Confirm responsibility for the interfaces between the coil, water circuit, controls and installation contractor.

A lower total may reflect a different construction, duty or scope. Record the differences before deciding whether the price comparison is meaningful.

Resolve missing information before acceptance

Keep one list of unresolved conditions, construction details and exclusions. Ask for revised documents when the agreed basis changes. Final suitability requires the project-specific engineering review and agreed acceptance process.

Send Taile your equipment schedule, design conditions and available drawings to discuss the proposed equipment and supply scope.

Send an enquiry · Chat on WhatsApp · Prepare selection inputs

WhatsApp Send drawings Contact Kalyn